Peel BondTM: Product Number 1146
Water Born, Clear, High Build Filling Primer, VOC: less than 100 g/l

• Fast drying, penetrating, filling primer for exterior applications

• Ideal for rough surfaces, T111 Siding, Plywood, Stucco, Brick,

• Can save hours of prep work

• Remains flexible

• Low temp, high humidity application

• Soap and water clean-up

• Top coat with exterior latex and elastomeric paints in 60 minutes

• Tintable with water based tint colors

Product Description: XIM’s Peel Bond is a unique, high build, water-based, penetrating, bonding primer/sealer. It is formulated to bond-to and seal a wide range of construction materials. It can reduce the cracking and peeling or the top coat paint by remaining flexible over the life of the paint. It can help reduce the time spent on surface Preparation, however, it is not a complete substitute for all surface preparation and all surface conditions.

Product Use: Peel Bond is an ideal prime coat for wood, plywood, hardboard and T1-11 siding, as well as other architectural construction materials including: stucco, brick, aluminum, galvanized metal, fiberglass, PVC plastic and PVC siding, and previously painted surfaces. Note: Peel Bond will not reattach loose or peeling paint, which must first be removed to a sound, stable surface. Peel Bond will not resolve underlying moisture problems inherent in or behind the substrate. Note: Peel Bond can help fill and level rough surfaces, however it is not intended as a replacement for wood fillers, caulk or drywall mud.

Product Preparation: Apply directly from the can, no thinning is required. If thinning is desired, use XIM’s Latex X-Tender. If tinting is desired, use up to 2 ounces of universal tint per gallon. Do not exceed 2 ounces of tint per gallon. It can also be tinted by adding small quantities of the Top Coat latex paint (½ Pint per gallon) to provide an opaque, guide coat. Mix or shake well before application.

Product Storage: Not to exceed 110° F.

Surface Preparation: Be sure the surface is clean and dry, free from dust, grease, wax, oil, and other surface contaminants. Clean with a strong detergent, rinse and allow to dry. Remove all loose and peeling paint. The surface should be a sound, stable surface. Spot prime areas that require extra filling. The moisture content of wood should be below 15% at application. Moldy or mildewed surfaces should be scrubbed with a mixture of one part of household bleach and three parts of water, then thoroughly rinsed with clean water and allowed to dry. Rotted wood should be replaced.

Application: Apply by synthetic fiber brush, synthetic roller or by spray. Can be applied at temperatures as low as 40° F. It can also be applied in high humidity conditions, up to 90% relative humidity. Under standard conditions, 77° F and 50% RH, Peel Bond will dry to touch in about 30 minutes. Thicker coats will take longer to dry. It can be top-coated in 40-60 minutes, under normal conditions. Peel Bond goes on white and dries to a hazy, clear. Once it has turned to the hazy, clear, it is ready to recoat or topcoat. It can be heavily applied, but do not exceed 25-30 mils wet film per application. Coverage will vary between 50 to 200 square feet per gallon, depending on dry film thickness.
BRUSH: Synthetic fiber brush designed for latex paints is recommended. Apply thickly.
ROLL: ½ inch nap synthetic fiber roller cover designed for latex paints. Roll in one direction.
SPRAY: 0.015 to 0.019 tip is recommended and 1200 psi. Sprays well with most sizes of spray equipment.

Clean Up: Clean up with soap and water immediately after use.