Hardwood Floor Reviver refreshes hardwood floors that are worn, scratched,
or dull. It is available in both High-Gloss and Low-Gloss sheens. Applying
Reviver requires no sanding or special preparation, just squirt onto
floor, spread with application tool and let dry. Provides beauty and
protection for 3-6 months.
•Sweep or vacuum the floor to remove all
•Wash the floor with a mild oil-free cleaner such as Minwax®
Hardwood Floor Cleaner
•Allow to dry completely
•Test Minwax® Hardwood Floor Reviver on a small inconspicuous
area of the floor such as inside a closet to ensure adhesion and compatibility.
Wax and other ingredients in some floor polishes may cause Reviver to
bead up or prevent it from adhering to the floor.
Note: Minwax® Hardwood Floor Reviver is not recommended for use
over unfinished, newly finished, waxed or oiled floors. To test for
wax, apply a few drops of water to the floor. Wait 10 minutes. If the
wetted area turns white, the floor may have a wax coating. Reviver is
not designed for use on floors that are in very poor condition. Badly
damaged floors or floors that have large areas where the finish is worn
away will require a complete refinishing.
the bottle several times before opening the cap. Do not shake.
•Squirt Minwax® Hardwood Floor Reviver lightly in an "S"
pattern directly onto the floor in a 3 x 3 foot area using a damp painter's
pad or synthetic applicator attached to a long handle, spread Reviver
across the floor.
•Work in the direction of the grain using a back-and-forth motion.
Keep working in small sections until the entire floor is coated. For
best results, apply a thin, even coat. Keep airborne dust to a minimum
while the floor is wet.
THE COATING TO DRY:
•Let the finish dry at least two hours
before walking lightly on the floor. Do not walk on the floor if the
surface is wet or tacky. Avoid heavy traffic and do not replace furniture
or rugs for 24 hours after application. When replacing furniture do
Hardwood Floor Reviver can be reapplied as needed (usually about every
6 months) to keep your floor looking beautiful.
Application tools can be easily cleaned with soap and water.