Commercial Grade Waterborne Wood Floor Sealer
is an advanced non-yellowing , low odor clear wood floor sealer which
penetrates the wood and dries quickly. It can be applied directly on
stained wood surfaces, or on raw wood. When used under oil modified
finish products, the sealer must be completely dry. DO NOT USE OVER
POLYURETHANE, LACQUER OR OTHER SEALED SURFACES. No Thinning Required.
Excellent for sealing most interior wood surfaces, including floors,
doors, cabinets, and furnitures.
Color in Container: Milky white (dries clear)
Solids Content: 25+/-1%
Chemical Resistance: Excellent
VOC: VOC does not exceed 275 grams/liter
Flash Point: 198°F
Pot Life: Unlimited in unopened container
Dry Time: 1 hour with good conditions
Clean Up: Water
Application method: T-Bar applicator, Synthetic waterborne applicator
and nylon brush.
Coverage: 600-700 sq. feet per gallon.
surface preparation is essential to achieve a high quality finish. Read
the MSDS sheet and wear properprotection, which may include gloves,
eye protection, and/or other protective devices.
New or Newly Sanded Floors or Wood Surfaces: Prepare the floor according
to NWFA or NOFMA accepted standard. The final pass before application
of sealer should be a #100 to #150 grit screen pad or sandpaper. Remove
dust completely by sweeping, vacuuming and wiping the floor or work
surface with a lint free cloth lightly dampened with water. The floor
or work surface and room temperature should be at least 65°F.
Apply sealer using standard water based finish techniques. Applicator
should be slightly dampened with finish before starting. Pour sealer
onto floor 4" strip along the starting wall. Apply the sealer with
the grain of wood. Pull the applicator towards you holding it at a slight
“snowplow” angle. Remember to keep a wet edge as you work.
When you reach the end wall, pull the applicator in a sweeping motion,
without lifting it from the floor. Feather turn, and gently touch any
missed spots. Apply at recommended coverage, in thin coats.
Last•n•Last 100 S should be dry to the touch in 1 hour.
Allow minimum of 1 hours before screening and for the topcoat to be
applied. Heavy finish application, high humidity or lack of airflow
will extend drying times.
Use water to clean brushes and applicators.