& Door Spar Varnish
Last•n•Last Marine and Door Spar Varnish will provide outstanding
protection for all types of exterior woodwork. Formulated to resist
mold and mildew, it is the clear choice for exterior protection of wood.
Manufactured using the highest quality resins, Last•n•Last
Marine and Door Spar Varnish will provide outstanding beauty and durability.
It contains UV absorbers for long lasting protection from the sun .
Adhesion is excellent – resists flaking and chipping.
For Exterior wood surfaces; including wooden boat above the
water line,doors,trims,outdoor furnitures,crafts,and railing . Not recommended
for decks and sidings.
Color in Container: Amber
Solids Content Weight: 51+/-1% for Gloss
52+/- 1% for Satin
Chemical Resistance: Excellent
VOC: 450 g/l
Flash Point 105°F
Sheen Gloss: No less than 90 units @ 60° on wood
Satin: 50-60 units @ 60° on wood
Freeze/Thaw Stability Stable
Dry Time: 4-6 hours under good conditions
Clean Up: Mineral Spirits
Application method: Good quality brush, or spray
Coverage Approx. :500 sq. feet per gallon.
surface preparation is essential to achieve a high quality finish. Read
the MSDS sheet and wear proper protection, which may include gloves,
eye protection, and/or other protective devices.
New or Newly Sanded Wood Surfaces:Make several passes with the sandpaper,
increasing the paper fineness with each pass. The final pass before
application ofLast•n•Last Marine and door spar varnish should
be with a #100 to #150 grit screen pad or sandpaper. Remove dust completely
by sweeping, vacuuming and wiping the work surface with a lint free
cloth lightly dampened with mineral spirits. The work surface and room
temperature should be at least 65°F.
Previously Finished Wood Surfaces:
Remove old finish in poor condition. Screen the work surface with #180
grit sand paper, maroon pad or similar. Remove dust completely by sweeping,
vacuuming and wiping the work surface with a lint free cloth lightly
dampened with mineral spirits. The floor or work surface and room temperature
should be at least 65°F.
Apply the finish with the grain of the wood. Apply in well
ventilated area with a good quality brush . Avoid applying the finish
in direct sunlight or when the weather is wet. Screen the work surface
in between coats with any of the following, #180 grit sand paper, maroon
pad or similar in between coats. Remember to vacuum and tack thoroughly
after screening to remove all dust. Heavy finish application, high humidity
or lack of airflow will extend drying times. If waiting longer than
24 hours between coats, sanding is recommended. On new wood, apply 3
coats for best results.
When applied according to directions, and in thin coats, Last•n•Last
Marine & Door Spar varnish should be dry to the touch in 4 hour.
Allow minimum of 4 to6 hours between coats. Heavy finish application,
high humidity or lack of airflow will extend drying times. Last·n·Last
Marine & Door Spar varnish completely cures within 2 weeks.
Use paint thinner, mineral spirits or turpentine to clean brushes
We recommend to recoat it periodically depending on the severity of
the outdoor conditions. We recommend Polycare Cleaner as the safe and
effective cleaning product. It has a unique soap-free, no rinse formula
which will not harm polyurethane or varnished wood surfaces.