BondTM: Product Number 1146
Water Born, Clear, High Build Filling Primer, VOC: less than 100 g/l
• Fast drying, penetrating, filling primer for exterior applications
• Ideal for rough surfaces, T111 Siding, Plywood, Stucco, Brick,
• Can save hours of prep work
Low temp, high humidity application
Soap and water clean-up
Top coat with exterior latex and elastomeric paints in 60 minutes
Tintable with water based tint colors
Description: XIM’s Peel Bond is a unique, high build,
water-based, penetrating, bonding primer/sealer. It is formulated to
bond-to and seal a wide range of construction materials. It can reduce
the cracking and peeling or the top coat paint by remaining flexible
over the life of the paint. It can help reduce the time spent on surface
Preparation, however, it is not a complete substitute for all surface
preparation and all surface conditions.
Use: Peel Bond is an ideal prime coat for wood, plywood, hardboard
and T1-11 siding, as well as other architectural construction materials
including: stucco, brick, aluminum, galvanized metal, fiberglass, PVC
plastic and PVC siding, and previously painted surfaces. Note: Peel
Bond will not reattach loose or peeling paint, which must first be removed
to a sound, stable surface. Peel Bond will not resolve underlying moisture
problems inherent in or behind the substrate. Note: Peel Bond can help
fill and level rough surfaces, however it is not intended as a replacement
for wood fillers, caulk or drywall mud.
Preparation: Apply directly from the can, no thinning is required.
If thinning is desired, use XIM’s Latex X-Tender. If tinting is
desired, use up to 2 ounces of universal tint per gallon. Do not exceed
2 ounces of tint per gallon. It can also be tinted by adding small quantities
of the Top Coat latex paint (½ Pint per gallon) to provide an
opaque, guide coat. Mix or shake well before application.
Storage: Not to exceed 110° F.
Preparation: Be sure the surface is clean and dry, free from
dust, grease, wax, oil, and other surface contaminants. Clean with a
strong detergent, rinse and allow to dry. Remove all loose and peeling
paint. The surface should be a sound, stable surface. Spot prime areas
that require extra filling. The moisture content of wood should be below
15% at application. Moldy or mildewed surfaces should be scrubbed with
a mixture of one part of household bleach and three parts of water,
then thoroughly rinsed with clean water and allowed to dry. Rotted wood
should be replaced.
Apply by synthetic fiber brush, synthetic roller or by spray. Can be
applied at temperatures as low as 40° F. It can also be applied
in high humidity conditions, up to 90% relative humidity. Under standard
conditions, 77° F and 50% RH, Peel Bond will dry to touch in about
30 minutes. Thicker coats will take longer to dry. It can be top-coated
in 40-60 minutes, under normal conditions. Peel Bond goes on white and
dries to a hazy, clear. Once it has turned to the hazy, clear, it is
ready to recoat or topcoat. It can be heavily applied, but do not exceed
25-30 mils wet film per application. Coverage will vary between 50 to
200 square feet per gallon, depending on dry film thickness.
BRUSH: Synthetic fiber brush designed for latex paints is recommended.
ROLL: ½ inch nap synthetic fiber roller cover designed for latex
paints. Roll in one direction.
SPRAY: 0.015 to 0.019 tip is recommended and 1200 psi. Sprays well with
most sizes of spray equipment.
Up: Clean up with soap and water immediately after use.